Carpets dry in 30 mins

Kills dust mites, dog and cat fleas without chemicals



Touch dry in 1 hour!

Cleaned & stain protected all-in-one process


Hard Floors

Safe to walk on immediately

Leaves grout and tiles looking like new


Curtain Cleaning

No need to take down

Your curtains are safely dry cleaned on site


Ashbourne Carpet Cleaning

October 12, 2014

Ashbourne carpet cleaning customers can now have there carpet cleaning in Ashbourne and the surrounding areas carried out using our unique carpet cleaning system that gives you the customer amazing benefits never before available to customers. We have a new product launch called M POWER it is one of the most Eco-friendly cleaning solutions available, M-Power is derived from renewable/sustainable sources, Fully Biodegradable, Non-toxic to humans, pets and aquatic life, Non-fuming – Non-hazardous – Non-polluting and not tested on animals
And best of all. Your carpets are dry in 30 minutes

Call 07718485101 today to discuss your cleaning requirements

How well does your vacuum filter? when you use it at home

Filtration should be measured by overall dust capture from all possible escape points (filters, body seams, vacuum tools, point of contact with the surface) rather than just the actual filter media.

Uprights have one unique point of vulnerability: the interface between the beater brush opening and the floor covering. When the floor covering is “beaten” or agitated, dust can become airborne if the airflow, lift and air speed does not remove it. The wide orifice that accommodates the beater brush can lower air velocity and cleaning ability if the ratio of airflow factors to orifice-width is not optimal.

Does the vacuum have HEPA media? Great. Microfilter media? This can work equally well in non-cleanroom applications. Remember, the entire system needs to be considered to determine overall dust capture, not just the type of filters.  Similarly, are airflow and suction balanced to enable the filters to trap the dust without blowing it through the media?

How are the body integrity and seals? Is the machine engineered using close tolerances and good seals to prevent dust from escaping where it shouldn’t?

Comments are closed.